City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch. For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

3. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   The Unified thread angle is 60° and has flattened crests (Whitworth crests are rounded). From 1 ⁄ 4 in up to 1 + 1 ⁄ 2 in, thread pitch is the same in both systems except that the thread pitch for the 1 ⁄ 2 in bolt is 12 threads per inch (tpi) in BSW versus 13 tpi in the UNC. Thread form Whitworth thread form

4. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   For example, “.750-10 UNC-2A” is male (A) with a nominal major diameter of 0.750 inches, 10 threads per inch, and a class-2 fit; “.500-20 UNF-1B” would be female (B) with a 0.500-inch nominal major diameter, 20 threads per inch, and a class-1 fit. An arrow points from this designation to the surface in question. Manufacturing

5. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Designation. A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ...

6. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe Thread Form ASME B1.21M-1997 (R2013) Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread Form (55°) 1 ⁄ 4 ″-20 BSW ISO 68-1:1998: ISO general purpose screw threads ...

7. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   BS 93:2008 — British Association (B.A.) screw threads — Requirements. The angle of the thread is 47.5° [4] : 2 and the depth of thread is 0.6 times the pitch with rounded tops and bottoms. Thus, the shortening at the crest and root is given by 0.26817 p with a radius of 0.18083 p at both crest and root. [4] : 2 The 1884 report specifies a ...