Ads
related to: temperature controller with analog output switchglobalspec.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
An asymmetric application, for example, is temperature control in HVAC systems using only active heating (via a heating element), where there is only passive cooling available. When it is desired to lower the controlled temperature the heating output is off, but there is no active cooling due to control output.
This "control air" system responds to the pressure changes (due to temperature) in the control tube to activate heating or cooling when required. The control air typically is maintained on "mains" at 15-18 psi (although usually operable up to 20 psi). Pneumatic thermostats typically provide output/ branch/ post-restrictor (for single-pipe ...
The unit controllers typically have analog and digital inputs that allow measurement of the variable (temperature, humidity, or pressure) and analog and digital outputs for control of the transport medium (hot/cold water and/or steam). Digital inputs are typically (dry) contacts from a control device, and analog inputs are typically a voltage ...
A potentiometer is a three- terminal resistor with a sliding or rotating contact that forms an adjustable voltage divider. [ 1] If only two terminals are used, one end and the wiper, it acts as a variable resistor or rheostat . The measuring instrument called a potentiometer is essentially a voltage divider used for measuring electric potential ...
A voltage-controlled oscillator ( VCO) is an electronic oscillator whose oscillation frequency is controlled by a voltage input. The applied input voltage determines the instantaneous oscillation frequency. Consequently, a VCO can be used for frequency modulation (FM) or phase modulation (PM) by applying a modulating signal to the control input ...
The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.
Ads
related to: temperature controller with analog output switchglobalspec.com has been visited by 10K+ users in the past month