Search results
Results From The WOW.Com Content Network
1% m/v solutions are sometimes thought of as being gram/100 mL but this detracts from the fact that % m/v is g/mL; 1 g of water has a volume of approximately 1 mL (at standard temperature and pressure) and the mass concentration is said to be 100%. To make 10 mL of an aqueous 1% cholate solution, 0.1 grams of cholate are dissolved in 10 mL of ...
0.019 336 77 psi. The torr (symbol: Torr) is a unit of pressure based on an absolute scale, defined as exactly 1 760 of a standard atmosphere (101325 Pa). Thus one torr is exactly 101325 760 pascals (≈ 133.32 Pa). Historically, one torr was intended to be the same as one "millimeter of mercury", but subsequent redefinitions of ...
The poise is often used with the metric prefix centi-because the viscosity of water at 20 °C (standard conditions for temperature and pressure) is almost exactly 1 centipoise. [3] A centipoise is one hundredth of a poise, or one millipascal-second (mPa⋅s) in SI units (1 cP = 10 −3 Pa⋅s = 1 mPa⋅s). [4] The CGS symbol for the centipoise ...
10 Ba. The pascal (symbol: Pa) is the unit of pressure in the International System of Units (SI). It is also used to quantify internal pressure, stress, Young's modulus, and ultimate tensile strength. The unit, named after Blaise Pascal, is an SI coherent derived unit defined as one newton per square metre (N/m 2 ). [1]
The bar is a metric unit of pressure defined as 100,000 Pa (100 kPa), though not part of the International System of Units (SI). A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar). [1] [2] By the barometric formula, 1 bar is roughly the atmospheric pressure on Earth ...
The effect of pressure and temperature on the densities of liquids and solids is small. The compressibility for a typical liquid or solid is 10 −6 bar −1 (1 bar = 0.1 MPa) and a typical thermal expansivity is 10 −5 K −1. This roughly translates into needing around ten thousand times atmospheric pressure to reduce the volume of a ...
In science and engineering, the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities, e.g. mole fraction or mass fraction. Since these fractions are quantity-per-quantity measures, they are pure numbers with no associated units of measurement. Commonly used are parts-per-million ( ppm ...
The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...