Search results
Results From The WOW.Com Content Network
The plots at the bottom show the signal intensity in the indicated row of the image (red: original signal, blue: with noise). Signal-to-noise ratio ( SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power ...
Wide FM, 20.0 kHz width, ±5 kHz deviation, still widely used for amateur radio, NOAA weather radio, marine, and aviation users and land mobile users below 50 MHz [2] 11K2 F3E Narrow FM, 11.25 kHz bandwidth, ±2.5 kHz deviation – In the United States, all Part 90 Land Mobile Radio Service (LMRS) users operating above 50 MHz were required to ...
is the reference distance, usually 1 km (or 1 mile) for a large cell and 1 m to 10 m for a microcell. [1] is the path loss exponent. is a normal (Gaussian) random variable with zero mean, reflecting the attenuation (in decibels) caused by flat fading [citation needed]. In the case of no fading, this variable is 0.
For the music theory concept of "modes", see Mode (music). In statistics, the mode is the value that appears most often in a set of data values. [ 1 ] If X is a discrete random variable, the mode is the value x at which the probability mass function takes its maximum value (i.e., x=argmaxxi P (X = xi) ). In other words, it is the value that is ...
Frequency deviation ( ) is used in FM radio to describe the difference between the minimum or maximum extent of a frequency modulated signal, and the nominal center or carrier frequency. The term is sometimes mistakenly used as synonymous with frequency drift, which is an unintended offset of an oscillator from its nominal frequency.
Likelihood-ratio test. In statistics, the likelihood-ratio test is a hypothesis test that involves comparing the goodness of fit of two competing statistical models, typically one found by maximization over the entire parameter space and another found after imposing some constraint, based on the ratio of their likelihoods.
The mean and the standard deviation of a set of data are descriptive statistics usually reported together. In a certain sense, the standard deviation is a "natural" measure of statistical dispersion if the center of the data is measured about the mean. This is because the standard deviation from the mean is smaller than from any other point.
Thus standard deviation about the mean is lower than standard deviation about any other point, and the maximum deviation about the midrange is lower than the maximum deviation about any other point. The 1-norm is not strictly convex, whereas strict convexity is needed to ensure uniqueness of the minimizer. Correspondingly, the median (in this ...