Search results
Results From The WOW.Com Content Network
Cellos exist in a smaller range of sizes than violins, with 4/4, 3/4, 1/2, 1/4, 1/8, and 1/10 being reasonably common. As with the violin, the Stradivarius scale is regarded as standard for orchestral work; This is about 27.4 inches (700 mm). Violas are commonly described in terms of their body length rather than by a fraction. There are two ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
British Standard Pipe ( BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external ( male) thread with an internal (female) thread. It has been adopted as standard in plumbing and pipe fitting, except in North America, where NPT and ...
However, the 3 + 1 ⁄ 2-inch (89 mm) 12-gauge shell, with its higher SAAMI pressure rating of 14,000 psi (97 MPa) compared to standard 2 + 3 ⁄ 4-inch (70 mm) and 3-inch (76 mm) 12-gauge shells with their lower pressure rating of 11,500 psi (79 MPa), began to approach the performance of the 3 + 1 ⁄ 2-inch (89 mm) 10-gauge shells with a ...
As a measurement of length. The term caliber is used as a measure of length of artillery barrels from muzzle to breech, expressed as a multiple of the bore diameter. For example, a 4-inch gun of 50 calibers would have a barrel 4 in × 50 = 200 in long (written as 4" L/50 or 4"/50).
The first commonly available increase in tape length resulted from a reduction in backing thickness from 1.5 to 1.0 mil (38 to 25 μm) resulting in a total thickness reduction from 42 to 35 μm (1.7 to 1.4 mils), which allowed 3,600 ft (1,100 m), 1,800 ft (550 m), and 900 ft (270 m) tapes to fit on ten-and-a-half-, seven-, and five-inch reels respectively.
Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw
The microwave is between 1 meter to 1 millimeter. The millimetre ( international spelling; SI unit symbol mm) or millimeter ( American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length. Therefore, there are one thousand millimetres in a metre.