Search results
Results From The WOW.Com Content Network
While at S&W, he was instrumental in the development of the large-framed S&W automatics, the 645 and later the 4506 and 1006 pistols. His prototypes, dubbed Supergun and Supergun II, were giving the 1911s of the day a run for their money. Tommy was also the co-developer of the .40 S&W cartridge, along with Paul Liebenberg.
Don't forget to get a QLS setup, there are 3 types. This is the attachment for the holster to the belt. The holster does not use the regular ELS mount. I had to order one after the fact. Also, you can order most of the mag pouches with the ELS 34 and 35 already attached, so you don't need to order a 10 pack.
Posted May 19, 2017 (edited) I have found the Safariland holster that I am looking for, for my CZ Shadow 2, and am very happy with my purchase. The fit is superb and the adjustment screws guarantee a tight grip. I found the fit to my Shadow 2 to be perfect. Overall well made.
Safariland has been made aware of a situation where the Provo, UT Police Department experienced malfunctions while training with the 6360 ALS holster on the range. The range in question is covered with approximately 4-6 deep, loose pea gravel.
Safariland is really good with customer service, and a couple of times I have called and asked for little parts (shims and srews) and they sent them gratis. last time i called to try and buy a muzzle platform aluminium arm and they said they didn't sell that part or offer it as a replacement. So, some parts are apparently not available.
Classified. 95. Gender:Male. Location:Las Vegas. Posted May 21, 2015. I wear a 32"-33" pants, and got a 34" inner and a 36" outer on Safariland's suggestions. The hook side Velcro on the inner overlaps with no spare room (I tend to wear my belt right on the top of my hips) and I've got 5 extra holes on my outer belt.
Safariland does have a belt with the QLS hole spacing but I think it is 2-1/4" wide, no idea if it also accepts ELS without drilling. What I found with adapting things to the ELS system is: I need to be willing to fiddle around, not be afraid to drill holes, use oddball screws, search the specialty screw bins at the hardward store and not be ...
There are lots of videos on Safariland's website about how to set up the ELS plates, etc., but nothing about the inner/outer belt arrangement. Probably because everyone but me gets it... Hate to sound stupid, but it ain't the first time! Thanks. Edited December 6, 2012 by shuter
Location:Alpharetta,GA between two ponds. Hello: I use the 771's for single stack since they release easier and smoother than the 773's for me. I just use a Unkle Mikes double mag holder for my 1911's in IDPA. Hope this helps and welcome Thanks, Eric.
Posted October 15, 2002. The holster is very snug both on draw and returning to holster. I have to look carefully where I am holstering the pistol, and slide it in the exact right spot or the holster binds on the cylinder. The same issue happens when drawing, the cylinder is gripped excessivly tight, and I must carefully pull it at the right angle.