Search results
Results From The WOW.Com Content Network
Electronic throttle control ( ETC) is an automobile technology that uses electronics to replace the traditional mechanical linkages between the driver's input such as a foot pedal to the vehicle's throttle mechanism which regulates speed or acceleration. This concept is often called drive by wire, [ 1][ 2] and sometimes called accelerate-by ...
Invention. Robert Dahlander. Robert Dahlander, a Swedish engineer working for ASEA, [ 3] discovered that switching the poles in a motor led to a reduction in the speed of the motor. In 1897 he invented an electrical configuration to switch between poles in a motor for which he was granted a patent along with his co-worker Karl Arvid Lindström.
Dead man's switch. A pedal acting as a dead man's switch in a bucket lift truck. A dead man's switch is a switch that is designed to be activated or deactivated if the human operator becomes incapacitated, such as through death, loss of consciousness, or being bodily removed from control. Originally applied to switches on a vehicle or machine ...
A throttle position sensor ( TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
Regenerative braking is a two-step process involving the motor/generator and the battery. The initial kinetic energy is transformed into electrical energy by the generator and is then converted into chemical energy by the battery. This process is less efficient than the flywheel. The efficiency of the generator can be represented by:
The cruise control takes its speed signal from a rotating driveshaft, speedometer cable, wheel speed sensor from the engine's RPM, or internal speed pulses produced electronically by the vehicle. Most systems do not allow the use of the cruise control below a certain speed - typically around 25 or 30 mph (40 or 48 km/h).
Bicycle pedals are left-threaded on the left-hand crank so that precession tightens the pedal rather than loosening it. This may seem counter-intuitive since the pedals rotate in the direction that would unscrew them from the cranks, but the torque exerted due to the precession is several orders of magnitude greater than that caused by bearing friction or even a jammed pedal bearing.
Cadence (cycling) In cycling, cadence is a measure of rotational speed of the crank, expressed in units of revolutions per minute (r/min or rpm). In other words, it is the pedalling rate at which a cyclist is turning the pedals. Cadence is directly proportional to wheel speed, but is a distinct measurement and changes with gearing.