City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   Spanner (Wrench) size. To simplify matters, the term hexagon is used in this section to denote either bolt head or nut. Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter).

3. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space between the nut flats and the bolt flats. This means that the wrench slips easily over the bolt, and can be removed ...

4. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Socket set with ratchet (above), four hex sockets and a universal joint. A socket wrench (or socket spanner) is a type of spanner (or wrench [1] in North American English) that uses a closed socket format, rather than a typical open wrench/spanner to turn a fastener, typically in the form of a nut or bolt. [2]

5. Remove Stubborn Nuts and Bolts With These Editor-Approved ...

   www.aol.com/lifestyle/best-adjustable-wrenches...

   This versatile tool does the job of an entire set of fixed wrenches. Skip to main content. Sign in. Mail. 24/7 Help. For premium support please call: 800-290-4726 more ways to reach ...

6. Nut driver - Wikipedia

   en.wikipedia.org/wiki/Nut_driver

   An Easco spinner handle with a detachable 1⁄4 in (6.35 mm) socket attached. A nutdriver or nut driver is a hand tool for tightening or loosening nuts and bolts. It essentially consists of a socket attached to a shaft and cylindrical handle and is similar in appearance and use to a screwdriver. [1] They generally have a hollow shaft to ...

7. British Association screw threads - Wikipedia

   en.wikipedia.org/wiki/British_Association_screw...

   BS 93:2008 — British Association (B.A.) screw threads — Requirements. The angle of the thread is 47.5° [4] : 2 and the depth of thread is 0.6 times the pitch with rounded tops and bottoms. Thus, the shortening at the crest and root is given by 0.26817 p with a radius of 0.18083 p at both crest and root. [4] : 2 The 1884 report specifies a ...