Ad
related to: 9 3/4 inch to mm wrench equivalent
Search results
Results From The WOW.Com Content Network
British Standard Whitworth(BSW) is an imperial-unit-based screw threadstandard, devised and specified by Joseph Whitworthin 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF, BSP, BSCon, and BSCopper. History.
Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.
The drill sizes that are near this are 9.3 mm (0.366 in) and letter U (0.368 in). In addition, 9.5 mm (0.374 in), and 3 ⁄ 8 in (0.375 in) will work well, although major minus pitch by itself does not tell you this; but the 85% ± 2 pp guideline supports it.
The design was first proposed by the British Association in 1884 [1] [2] with a thread angle and depth based on the Swiss Thury thread, [3] it was adopted by the Association in 1903. The Thury thread was different in that it went both positive and negative all the way up to a size of −20 which was 75.2 mm diameter by 8.23 mm pitch (p). The ...
So a 1 / 2 in (12.7 mm) diameter drill will be able to drill a hole 4 + 1 / 2 in (114.3 mm) deep, since it is 9 times the diameter in length. A 1 / 8 in (3.175 mm) diameter drill can drill a hole 1 + 5 / 8 in (41.275 mm) deep, since it is 13 times the diameter in flute length. [3]
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
These drive fittings come in four common sizes: 1 ⁄ 4 inch, 3 ⁄ 8 inch, 1 ⁄ 2 inch, and 3 ⁄ 4 inch (referred to as "drives", as in "3 ⁄ 8 drive"). Despite being denominated in inches, these are trade names ( common product name ), and manufacturers construct them to 6.3 mm, 9.5 mm, 12.5 mm and 19 mm, having been rounded to a ...
Ad
related to: 9 3/4 inch to mm wrench equivalent