City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Bolt cutter - Wikipedia

   en.wikipedia.org/wiki/Bolt_cutter

   Bolt cutters are usually available in 12, 14, 18, 24, 30, 36 and 42 inches (30.5, 35.6, 46, 61, 76, 91.4 and 107 cm) in length. The length is measured from the tip of the jaw to the end of the handle. Angle cut has the cutter head angled for easier insertion. Typical angling is 25 to 35 degrees. Center cut has the blades equidistant from the ...

3. List of United States Coast Guard cutters - Wikipedia

   en.wikipedia.org/wiki/List_of_United_States...

   175' Keeper-class coastal buoy tender (WLM) USCGC Joshua Appleby (WLM-556), a 175' USCG coastal buoy tender. USCGC Ida Lewis (WLM-551) USCGC Katherine Walker (WLM-552) USCGC Abbie Burgess (WLM-553) USCGC Marcus Hanna (WLM-554) USCGC James Rankin (WLM-555) USCGC Joshua Appleby (WLM-556) USCGC Frank Drew (WLM-557)

4. Anvil - Wikipedia

   en.wikipedia.org/wiki/Anvil

   A blacksmith working with a sledgehammer, assistant (striker) and Lokomo anvil in Finland. An anvil is a metalworking tool consisting of a large block of metal (usually forged or cast steel), with a flattened top surface, upon which another object is struck (or "worked"). Anvils are massive because the higher their inertia, the more efficiently ...

5. Legend-class cutter - Wikipedia

   en.wikipedia.org/wiki/Legend-class_cutter

   50-by-80-foot (15 m × 24 m) flight deck, hangar for all aircraft. The Legend-class cutter, also known as the National Security Cutter ( NSC) and Maritime Security Cutter, Large, is the largest active patrol cutter class of the United States Coast Guard, with the size of a frigate. Entering into service in 2008, the Legend class is the largest ...

6. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Cross-hole countersink cutter. A cross-hole, "Weldon style" or "zero flute" countersink is a cone-shaped tool with a cutting edge provided by a hole that goes through the side of the cone. The intersection of the hole and cone form the cutting edge on the tool. The cone is not truly symmetrical as it is essential that the cone retreats away ...

7. Broaching (metalworking) - Wikipedia

   en.wikipedia.org/wiki/Broaching_(metalworking)

   A broached keyway in the end of an adjustable wrench. Broaching is a machining process that uses a toothed tool, called a broach, to remove material. There are two main types of broaching: linear and rotary. In linear broaching, which is the more common process, the broach is run linearly against a surface of the workpiece to produce the cut.