City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Unified Thread Standard. The Unified Thread Standard ( UTS) defines a standard thread form and series—along with allowances, tolerances, and designations—for screw threads commonly used in the United States and Canada. It is the main standard for bolts, nuts, and a wide variety of other threaded fasteners used in these countries.

3. Planters illegally bolted to an L.A. street to deter RV ...

   www.aol.com/news/did-home-depot-staff-bolt...

   After the area was cleared, men wearing the signature Home Depot aprons installed the steel tubs and appeared to bolt them to the city street with power tools, according to a post from the X ...

4. Bolt cutter - Wikipedia

   en.wikipedia.org/wiki/Bolt_cutter

   A bolt cutter, sometimes called bolt cropper, is a tool used for cutting bolts, chains, padlocks, rebar and wire mesh. It typically has long handles and short blades, with compound hinges to maximize leverage and cutting force. A typical bolt cutter yields 20 kilonewtons (4,500 lb f) of cutting force for a 250 newtons (56 lb f) force on the ...

5. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Washer (hardware) Assorted washers: flat, split, star and insulating. A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut. Other uses are as a spacer, spring ( Belleville washer, wave washer), wear ...

6. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   The Unified thread angle is 60° and has flattened crests (Whitworth crests are rounded). From 1 ⁄ 4 in up to 1 + 1 ⁄ 2 in, thread pitch is the same in both systems except that the thread pitch for the 1 ⁄ 2 in bolt is 12 threads per inch (tpi) in BSW versus 13 tpi in the UNC. Thread form Whitworth thread form

7. Higbee cut - Wikipedia

   en.wikipedia.org/wiki/Higbee_cut

   A Higbee cut is a specific cut added to a screw thread to produce a blunt start, instead of the sharp end of the unmodified screw thread. It is named for its inventor Clinton Higbee. The presence of a Higbee cut on both male and female threads eliminates the chance of cross threading. A blunt start thread possessing a Higbee cut is also known ...