Search results
Results From The WOW.Com Content Network
The ipconfig command supports the command-line switch /all. This results in more detailed information than ipconfig alone. An important additional feature of ipconfig is to force refreshing of the DHCP IP address of the host computer to request a different IP address. This is done using two commands in sequence.
The CPU uses the values of CS and IP registers to find the location of the next instruction to execute. Location of next instruction is calculated using this simple equation: Location of next instruction = (CS<<4) + (IP) This implies that after the hardware reset, the CPU will start execution at the physical address 0xFFFF0.
On a PC running Windows 10: On the task bar, select WiFi or Ethernet > click on the network you’re currently connected to > select Properties > your IP address is listed next to “IPv4 address ...
netstat. In computing, netstat (network statistics) is a command-line network utility that displays network connections for Transmission Control Protocol (both incoming and outgoing), routing tables, and a number of network interface (network interface controller or software-defined network interface) and network protocol statistics.
An Internet Protocol address (IP address) is a numerical label such as 192.0.2.1 that is assigned to a device connected to a computer network that uses the Internet Protocol for communication. [1][2] IP addresses serve two main functions: network interface identification, and location addressing. Internet Protocol version 4 (IPv4) defines an IP ...
Command. ifconfig (short for interface config) is a system administration utility in Unix-like operating systems for network interface configuration. The utility is a command-line interface tool and is also used in the system startup scripts of many operating systems. It has features for configuring, controlling, and querying TCP/IP network ...
In computing, the reset vector is the default location a central processing unit will go to find the first instruction it will execute after a reset. The reset vector is a pointer or address, where the CPU should always begin as soon as it is able to execute instructions. The address is in a section of non-volatile memory (such as BIOS or Boot ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router