Search results
Results From The WOW.Com Content Network
Thus, encoding/decoding is the translation needed for a message to be easily understood. When you decode a message, you extract the meaning of that message in ways to simplify it. Decoding has both verbal and non-verbal forms of communication: Decoding behavior without using words, such as displays of non-verbal communication.
Binary decoder. In digital electronics, a binary decoder is a combinational logic circuit that converts binary information from the n coded inputs to a maximum of 2 n unique outputs. They are used in a wide variety of applications, including instruction decoding, data multiplexing and data demultiplexing, seven segment displays, and as address ...
An encoder (or "simple encoder") in digital electronics is a one-hot to binary converter. That is, if there are 2 n input lines, and at most only one of them will ever be high, the binary code of this 'hot' line is produced on the n -bit output lines. A binary encoder is the dual of a binary decoder . If the input circuit can guarantee at most ...
Low-density parity-check (LDPC) codes are a class of highly efficient linear block codes made from many single parity check (SPC) codes. They can provide performance very close to the channel capacity (the theoretical maximum) using an iterated soft-decision decoding approach, at linear time complexity in terms of their block length.
In many cases, they generally offer greater simplicity of implementation over a block code of equal power. The encoder is usually a simple circuit which has state memory and some feedback logic, normally XOR gates. The decoder can be implemented in software or firmware. The Viterbi algorithm is the optimum algorithm used to decode convolutional ...
In this regard, Berlo speaks of the source-encoder and the decoder-receiver. Treating the additional components separately is especially relevant for technical forms of communication. For example, in the case of a telephone conversation, the message is transmitted as an electrical signal and the telephone devices act as encoder and decoder.
Convolutional codes are often characterized by the base code rate and the depth (or memory) of the encoder . The base code rate is typically given as , where n is the raw input data rate and k is the data rate of output channel encoded stream. n is less than k because channel coding inserts redundancy in the input bits.
A binary code represents text, computer processor instructions, or any other data using a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits, to each character, instruction, etc. For example, a binary string of eight bits (which ...