City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The bolt circle's measurement is called the bolt circle diameter (BCD), [3] also called the pitch circle diameter (PCD). [4] The bolt circle diameter is typically expressed in mm and accompanies the number of bolts in your vehicle's bolt pattern. One example of a common bolt pattern is 5x100 mm. This means there are 5 bolts evenly spaced about ...

3. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs. Because of this UNS taps are readily available. [4] [5] Most UNS threads have more threads per inch than the ...

4. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   The minor diameter is the lower extreme diameter of the thread. Major diameter minus minor diameter, divided by two, equals the height of the thread. The minor diameter of a nut is its inside diameter. The minor diameter of a bolt can be measured with go/no-go gauges or, directly, with an optical comparator.

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Double hex is a screw drive with a socket shaped as two coaxial offset hex recesses; it can be driven by standard hex key tools. The shape resembles triple square and spline screw drives, but they are incompatible. The radial "height" of each arris is reduced, compared to a six-point, although their number is doubled.

7. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space between the nut flats and the bolt flats. This means that the wrench slips easily over the bolt, and can be removed ...