Search results
Results From The WOW.Com Content Network
A binary-to-text encoding is encoding of data in plain text. More precisely, it is an encoding of binary data in a sequence of printable characters. These encodings are necessary for transmission of data when the communication channel does not allow binary data (such as email or NNTP) or is not 8-bit clean. PGP documentation ( RFC 4880) uses ...
ASCII ( / ˈæskiː / ⓘ ASS-kee ), [3] : 6 an acronym for American Standard Code for Information Interchange, is a character encoding standard for electronic communication. ASCII codes represent text in computers, telecommunications equipment, and other devices.
A binary number is a number expressed in the base -2 numeral system or binary numeral system, a method for representing numbers that uses only two symbols for the natural numbers: typically "0" ( zero) and "1" ( one ). A binary number may also refer to a rational number that has a finite representation in the binary numeral system, that is, the ...
A binary coderepresents text, computer processor instructions, or any other datausing a two-symbol system. The two-symbol system used is often "0" and "1" from the binary number system. The binary code assigns a pattern of binary digits, also known as bits, to each character, instruction, etc. For example, a binary stringof eight bits (which is ...
This is a list of some binary codes that are (or have been) used to represent text as a sequence of binary digits "0" and "1". Fixed-width binary codes use a set number of bits to represent each character in the text, while in variable-width binary codes, the number of bits may vary from character to character.
The atree or Binary Ahnentafel method is based on the same numbering of nodes, but first converts the numbers to binary notation and then converts each 0 to M (for Male) and each 1 to F (for Female). The first character of each code (shown as X in the table below) is M if the subject is male and F if the subject is female.
Double dabble. In computer science, the double dabble algorithm is used to convert binary numbers into binary-coded decimal (BCD) notation. [1] [2] It is also known as the shift-and-add -3 algorithm, and can be implemented using a small number of gates in computer hardware, but at the expense of high latency. [3]
The Baudot code ( French pronunciation: [bodo]) is an early character encoding for telegraphy invented by Émile Baudot in the 1870s. [ 1] It was the predecessor to the International Telegraph Alphabet No. 2 (ITA2), the most common teleprinter code in use before ASCII. Each character in the alphabet is represented by a series of five bits, sent ...