City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch. For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

3. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   For example, “.750-10 UNC-2A” is male (A) with a nominal major diameter of 0.750 inches, 10 threads per inch, and a class-2 fit; “.500-20 UNF-1B” would be female (B) with a 0.500-inch nominal major diameter, 20 threads per inch, and a class-1 fit. An arrow points from this designation to the surface in question. Manufacturing

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.

5. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   The Unified thread angle is 60° and has flattened crests (Whitworth crests are rounded). From 1 ⁄ 4 in up to 1 + 1 ⁄ 2 in, thread pitch is the same in both systems except that the thread pitch for the 1 ⁄ 2 in bolt is 12 threads per inch (tpi) in BSW versus 13 tpi in the UNC. Thread form Whitworth thread form

6. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Designation. A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ...

7. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   This flat length is defined as the pitch divided by eight. The thread depth, which is from flat to flat is 0.6495 times the pitch. For 1 ⁄ 4-inch (6.4 mm) screws and larger, the pitch is defined as: = + where P is the pitch and D is the diameter of the rough stock. Background