Search results
Results From The WOW.Com Content Network
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
USB 2.0 provides for a maximum cable length of 5 metres (16 ft 5 in) for devices running at high speed (480 Mbit/s). The primary reason for this limit is the maximum allowed round-trip delay of about 1.5 μs. If USB host commands are unanswered by the USB device within the allowed time, the host considers the command lost.
In USB 3.0, dual-bus architecture is used to allow both USB 2.0 (Full Speed, Low Speed, or High Speed) and USB 3.0 (SuperSpeed) operations to take place simultaneously, thus providing backward compatibility. The structural topology is the same, consisting of a tiered star topology with a root hub at level 0 and hubs at lower levels to provide ...
USB 2.0 high-speed device, compatible USB 1.1, PC & Mac, USB Host port compatible Mass Storage Device; Earphones / Audio & Video line out, Microphone in: Power: Battery: 10 hours for music, 5 hours for video on built-in LCD: Dimensions: 4.2 in x 2.4 in x 0.7 in: Mass: 5.6 oz
Appearance. This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels. The distinction can be arbitrary between a computer bus, often closer in space, and larger telecommunications ...
A USB and Firewire Host Controller Interface ( UFHC) is a register-level interface that enables a host controller for USB or IEEE 1394 hardware to communicate with a host controller driver in software. The driver software is typically provided with an operating system of a personal computer, but may also be implemented by application-specific ...
USB Attached SCSI. USB Attached SCSI ( UAS) or USB Attached SCSI Protocol ( UASP) is a computer protocol used to move data to and from USB storage devices such as hard drives (HDDs), solid-state drives (SSDs), and thumb drives. UAS depends on the USB protocol, and uses the standard SCSI command set.
Ever think what your life would be like without high-speed Web access? Frankly, I can't imagine it, and maybe you can't either. Whether as a productivity tool for work or life or both, broadband ...