Search results
Results From The WOW.Com Content Network
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
The throughput of each USB port is determined by the slower speed of either the USB port or the USB device connected to the port. High-speed USB 2.0 hubs contain devices called transaction translators that convert between high-speed USB 2.0 buses and full and low speed buses. There may be one translator per hub or per port.
USB On-The-Go ( USB OTG or just OTG) is a specification first used in late 2001 that allows USB devices, such as tablets or smartphones, to also act as a host, allowing other USB devices, such as USB flash drives, digital cameras, mouse or keyboards, to be attached to them. Use of USB OTG allows devices to switch back and forth between the ...
In USB 3.0, dual-bus architecture is used to allow both USB 2.0 (Full Speed, Low Speed, or High Speed) and USB 3.0 (SuperSpeed) operations to take place simultaneously, thus providing backward compatibility. The structural topology is the same, consisting of a tiered star topology with a root hub at level 0 and hubs at lower levels to provide ...
To allow high-speed (USB 2.0) devices to operate in their fastest mode, all hubs between the devices and the computer must be high-speed. High-speed devices should fall back to full-speed (USB 1.1) when plugged into a full-speed hub (or connected to an older full-speed computer port). While high-speed hubs can communicate at all device speeds ...
Sideloading typically refers to media file transfer to a mobile device via USB, Bluetooth, WiFi or by writing to a memory card for insertion into the mobile device, but also applies to the transfer of apps from web sources that are not vendor-approved. When referring to Android apps, "sideloading" typically means installing an application ...
USB-C plug. USB-C (SuperSpeed USB 5Gbps) receptacle on an MSI laptop. USB-C, or USB Type-C, is a 24-pin connector (not a protocol) that supersedes previous USB connectors and can carry audio, video, and other data, e.g., to connect to monitors or external drives. It can also provide and receive power, to power, e.g., a laptop or a mobile phone.
High-Speed Uplink Packet Access ( HSUPA) is a 3G mobile telephony protocol in the HSPA family. It is specified and standardized in 3GPP Release 6 to improve the uplink data rate to 5.76 Mbit/s, extend capacity, and reduce latency. Together with additional improvements, this allows for new features such as Voice over Internet Protocol (VoIP ...