City Pedia Web Search

Search results

1. Results From The WOW.Com Content Network

2. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs. Because of this UNS taps are readily available. Most UNS threads have more threads per inch than the correlating ...

3. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   For example, “.750-10 UNC-2A” is male (A) with a nominal major diameter of 0.750 inches, 10 threads per inch, and a class-2 fit; “.500-20 UNF-1B” would be female (B) with a 0.500-inch nominal major diameter, 20 threads per inch, and a class-1 fit. An arrow points from this designation to the surface in question. Manufacturing

4. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

5. Trapezoidal thread form - Wikipedia

   en.wikipedia.org/wiki/Trapezoidal_thread_form

   The actual thread heights on both the internal (nut) and external (bolt) threads differ from ⁠ P / 2 ⁠ by allowances (or clearances): A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches.

6. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   Designation. A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ...

7. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   The Unified thread angle is 60° and has flattened crests (Whitworth crests are rounded). From 1 ⁄ 4 in up to 1 + 1 ⁄ 2 in, thread pitch is the same in both systems except that the thread pitch for the 1 ⁄ 2 in bolt is 12 threads per inch (tpi) in BSW versus 13 tpi in the UNC. Thread form Whitworth thread form